Replace Batteries for 9KZ and 40HZ Locks

Battery Life

Genuine factory battery packs are designed for maximum service life.Depending on the type of chassis you have, the average life of a battery pack is shown in the table below.

Replacing batteries

When replacing batteries, the memory is not lost, but the time setting is lost after two minutes. The Keypad EZ Lock has a warning system to let you know when the batteries are getting low. At the first sign of warning, although you have some time to replace the batteries before they fail, you need to replace the battery pack or batteries as soon as possible.

Use the following table to determine a Keypad EZ Lock’s level when a valid Pin is entered.

To replace batteries for 9KZ and 40HZ locks:

1. Use a T20 Torx bit or Phillips Type 2 to remove the two inside cover screws from either side of the top cover.

2. Slide the top cover up and remove it from the fire plate.

3. Disconnect the battery holder from the connector and remove it from the fire plate. See Figure 4.1 on page 20.

4. Remove the battery holder screw and slide the holder lid off.

5. Replace the batteries in the holder with aa Duracell or Energizer aa alkaline batteries only.

6. Slide the battery holder lid back on and replace the battery holder screw.

7. Position the battery wires against the fire plate side wall and slide the battery holder back into the fire plate.

CAUTION: When routing the battery wires, make sure the wires are not routed across any sharp edges or over any surface that could damage their wire insulation.

8. Connect the battery holder to the connector.

9. Slide the top cover over the guide notches and replace the inside cover screws.

CAUTION: When connecting the battery pack, make sure that there are no loose wire connections where the wires are inserted into the connectors and that the connectors are firmly mated.


How did we do?


Powered by HelpDocs (opens in a new tab)

Powered by HelpDocs (opens in a new tab)